is detected, and after it was dropped, unplug the unit
and apply to the service center.
• Transport the coffee maker in the original package.
• Keep the unit out of reach of children and disabled
• persons.
COFFEE MAKER IS INTENDED FOR HOUSEHOLD
USE ONLY, DO NOT USE THE COFFEE MAKER FOR
COMMERCIAL OR LABORATORY PURPOSES.
BEFORE USING THE COFFEE MAKER
After unit transportation or storage at low
temperature, it is necessary to keep it for at least
three hours at room temperature.
• Unpack the coffee maker and remove all the
packaging materials.
• Keep the original package.
• Check the delivery set.
• Read the safety measures and operating
recommendations.
• Examine the coffee maker for damages, in case of
damage do not plug it into the mains.
• Make sure that the specications of power supply
voltage specied on the lower panel of the unit
correspond to the specications of your mains. When
the unit is used in the mains with 60 Hz frequency, it
does not need any additional settings.
• Wipe the surface of the coffee maker body with a
clean, slightly damp cloth to remove dust.
• Make sure that all the control buttons (10, 11, 12) are
in the off position.
• Make sure that the steam supply is closed. To do this
turn the knob (15) «
» clockwise until bumping
«•».
• Before using the coffee maker for the rst time, wash
all removable parts (5, 6, 17, 20, 21) with warm water
and dry them.
• Before switching the unit on, make sure that voltage
of the mains corresponds
• to unit operating voltage specied on the unit body.
When the unit is used in the mains with 60 Hz
frequency, it does not need any additional settings.
• Remove the water tank (20), ll it with cold water up
to the MAX mark and install it back to its place.
• Notes:
- to ll the water tank (20) with water you can lift the
lid (19), fold it back and pour water into the tank
(20).
- do not use the lid (19) to carry the water tank (20).
• Install the coffee lter (6) into the holder (5) having
preliminary matched the ledge on the lter (6) with
the groove on the holder (5) and turn the lter (6)
counter/clockwise to x the lter.
• Install the lter holder (5) into the coffee maker. The
holder (5) ledges should match the grooves on the
boiler «
», after that turn the lter holder handle
(4) to the right until bumping «
».
• Place a suitable cup on the grid (2).
• Insert the power plug into the mains socket.
• Switch the coffee maker on by pressing the on/off
button (11) «
», the indicator (7) « » will light up.
• To ll the boiler with water press the button (12) «
», wait for 15-20 seconds, or at the rst signs
of appearance of water in the cup, switch the water
supply off by pressing the button (12) «
» again.
• Wait until the indicator lights up, then switch the
water supply on by pressing the button (12) «
».
After the cup is lled with water, press the button (12)
«
» again to switch the water supply off and pour
the water out of the cup.
• Depending on the cup capacity repeat this procedure
several times until the boiler is clean.
HOW TO MAKE A GOOD ESPRESSO
• Use ground coffee for espresso coffee makers.
• Slightly tamp the ground coffee in the lter (6), you
can do it with the back side of the measuring spoon
(17).
• Coffee strength depends on the quality and grinding
degree of coffee beans. If coffee is pouring out too
long, this means the coffee powder is too ne or it is
tamped too strongly.
THERMOMETER
You can control the temperature by the indicators (8, 9)
and with the built-in thermometer (13). The thermometer
(13) scale shows the water temperature in the coffee
maker.
PREHEATING
• To make a cup of hot espresso, it is recommended to
preliminary heat up the coffee lter (6) and the lter
holder (5).
• Open the lid (19) and ll the tank (20) with water, or
remove the tank (20) and ll it with water, then install
the tank (20) back to its place.
• Install the coffee lter (6) into the holder (5) having
preliminary matched the ledge on the lter (6) with
the groove on the holder (5) and turn the lter (6)
counter/clockwise to x the lter.
ATTENTION!
• Do not remove the lter holder (5) when the
buttons (10, 12) are pressed.
• Do not remove the lter holder (5) immediately
after preparing coffee as there is redundant water
and steam pressure inside the lter (5), let the
coffee maker cool down completely.
• To remove the lter holder (5) turn the handle (4)
to the left «
» and remove the lter holder (5).
AUTO SWITCH OFF FUNCTION
• If no actions were performed during 25 minutes
after switching on, the coffee maker will switch off
automatically.
To Next Page
Loading...
