BRAYER BR1108 - Page 11

11
EN
• When the co󰀨ee maker is ready for operation, the light
indicator (7, 8, 9) will glow constantly.
• To make one cup of espresso, use the small lter (21)
and press the «Espresso»-button (7) once; the light
indicator « » will light up.
• To make two cups of espresso, use the larger lter (22)
and press the «Espresso»-button (7) twice; the light
indicator « » will light up. In this case set one big or
two small cups on the grid (2 or 3).
Notes:
- if you need to switch the co󰀨ee maker o󰀨 during the
espresso making, press the «Espresso»-button (7)
again;
- successive making of co󰀨ee should be performed
with intervals 2-3 min.
• Remove the cup with ready drink from the grid (2 or 3).
• After you nish using the co󰀨ee maker, switch the
co󰀨ee maker o󰀨 by setting the switch (11) «0/I» to the
position «0».
• Wait until the co󰀨ee maker cools down, remove the
lter holder (20) and wash the installed lter (21 or 22).
ESPRESSO PORTION SETTING
• When making espresso, press and hold the button
(7) «
» for 3 seconds, the one cup indicator « » will
be ashing. When the desired amount of espresso is
dispensed, release the button (7). The maximal amount
of one cup of co󰀨ee is about 90 ml.
• Next time when you make espresso, the preset amount
of ready co󰀨ee will be poured into the cup.
• When making espresso, press twice and hold the button
(7) «
» for 3 seconds, the two cups indicator « » will
be ashing. When the desired amount of espresso is
dispensed, release the button (7). Maximal amount of
double portion of co󰀨ee is about 130 ml.
• Next time when you make espresso, the preset amount
of ready co󰀨ee will be poured into the cup
Notes:
- minimal and maximal amount of espresso
are specied in the table «CHOOSING THE
APPROPRIATE CUP»;
- if you need to make a lesser amount of co󰀨ee then it
was set, press the button (7) again when the cup is
lled with necessary amount of ready co󰀨ee.
Return to the factory settings
• To return to the factory settings switch the co󰀨ee maker
o󰀨 by setting the switch (11) «0/I» to the position «0».
• Press and hold the button (7) «Espresso», switch the
co󰀨ee maker on by setting the power switch (11) «0/I»
to the position «I», the buttons «
» and « » indicators
will ash 5 times.
• The co󰀨ee maker is ready for operation with the factory
settings.