BRAYER BR1108 - Descaling Procedure; Scale Impact and Prevention; Descaling Agents and Frequency; Descaling Process Steps

16
EN
• After you nish using the co󰀨ee maker, switch the
co󰀨ee maker o󰀨 by setting the switch (11) «0/I» to the
position «0».
• Wait until the co󰀨ee maker cools down, take the
container (18), pull it towards yourself and remove it
(pic. 1), remove the cappuccinator lid (14) from the
container (18).
• Pour the remaining water out of the container (18), wipe
the container with a dry cloth and dry the cappuccinator
lid (16).
• Before assembling make sure that the cappuccinator lid
and the container are dry. Install the cappuccinator lid
(16) on the container (18) and install the cappuccinator
on the co󰀨ee maker.
DESCALING
• Scale inside the boiler a󰀨ects the taste of ready co󰀨ee,
slows down the co󰀨ee making and reduces the service
life of the co󰀨ee maker.
• Note that the thicker the scale, the more di󰀩cult it is to
remove, that’s why we recommen regularly removing
scale for e󰀨ective operation of the co󰀨ee maker (see
the table).
Water type Cleaning frequency
Soft (ltered) water Every 80 co󰀨ee making cycles
Hard (tap) water Every 40 co󰀨ee making cycles
• The buttons (7, 6, 9) light indicators ashing by rotation
will remind you about descaling.
• You can use special descaling agents for espresso co󰀨ee
makers or co󰀨ee machines to remove scale. You can also
use table vinegar or citric acid solution (2 teaspoons of
citric acid per 1 liter of water).
• Follow the instructions on the usage of the descaling
agent, pour it into the water tank (13).
• Install one of the co󰀨ee lters (21 or 22) into the lter
holder (20) matching the ledge on the lter (21 or 22) with
the hole on the holder (20) and turn the lter (21 or 22)
counter/clockwise.
• Place a cup of suitable height and capacity on the grid (2).
• Direct the cappuccinator pipe (15) into the cup using
the cappuccinator pipe angle adjustment bar (14), if
necessary, change the length of the cappuccinator pipe
(15) (g. 9).
• Insert the power plug into the mains socket.
• Switch the co󰀨ee maker on by setting the «0/I» power
switch (11) to the «I» position.
• To switch the cleaning mode on, press simultaneously the
button (9) «Latte» and the button (7) «Espresso».
• In the descaling mode the light indicators slowly ash
by rotation, after 30 minutes the light indicators will start
ashing faster. Remove the container (13), drain the
remaining descaling solution and ll the container (13) with
clean water. Install the container (13) back to its place.
• Pour the descaling solution out from the cup, place the
cup on the grid (2).