18
USING THE MULTICOOKER
Placing foodstu, checking the silicone gasket (15),
the internal state of the valve (17 and 18), connecting
the multicooker to the electrical network
• Place food in the bowl (5), observing the recipe for
cooking and the section on how to use the cooking
bowl.
• I•nstall the bowl (5) with food into the multicooker.
• Check the condition of the silicone gasket (15) (g. 2)
• Remove the inner lid (16) and check for clogging or
remains of food on the inner part (17) of the pressure
limiting valve (1) and on the inner part (18) of the oat
valve (2) (Fig. 3)
• Install the inner lid (16) to its place.
• Place the lid (4) in the initial place of installation (7) (g.
4), turn the lid (4) counterclockwise until bumping.
• Check that the pressure limiting valve (1) is in the
«Closed» position, if it is in the «Open» position, turn it
clockwise or counterclockwise.
• Insert the power cord plug (22) into the connector on
the multicooker body (10).
• Insert the power cord plug (22) into an electrical socket,
you will hear a sound signal on the control panel (9),
the backlight of all control buttons and the display will
light up, the multicooker is in standby mode (g. 5).
• By pressing the «Program» button (23) you can choose
a cooking program.
• Symbols (31) show the default pressure holding time in
the cooking program.
• By pressing the buttons (26) « » in the cooking
programs, you can set the pressure holding time, and in
the «Timer» program, the delay time for the start of the
cooking program.
Notes: setting the delay time for the start of the cooking
program is not available in the «Yogurt» and «Fry» programs.
• By pressing the «Functions» button (25) you can choose
the functions and cooking programs.
• By pressing the button (28) you can choose the modes of
cooking at high or low pressure, the cooking modes are
shown on the display with the ashing symbols (30) «High
Pressure» and «Low Pressure».
• Use the «High Pressure» mode (70-80kPa) in the «Meat»
cooking program.
• Use the «Low Pressure» mode (40-50kPa) in the «Pasta»
cooking program.
• In 5 seconds, the multicooker will turn on to work
according to the set cooking program, while the display
will show the symbol of the cooking program (29), if you
have chosen the cooking mode with high or low pressure,
the symbols (30) will show the chosen pressure mode,
digital symbols (31) will show the pressure holding time,
two groups of symmetrical lights indicators (32) will move
towards the center of the display (g. 6).
• During heating, the oat valve (2) rises and blocks the
opening of the lid (4), the pressure will increase in the
bowl (5). When the pressure reaches the set level, a small
amount of steam will begin to ow out of the pressure
limiting valve (1), the digital symbols (31) will show the
To Next Page
Loading...
