10
(17) «-» in standby mode, you will hear a sound signal.
Locking the control panel
• For additional protection, the appliance has a control
panel lock feature that prevents accidental button
presses.
• To lock the control panel in any mode, except setting
before
• start, press and hold the button (16) «+», you will hear
a sound signal. The
• display (13) will show the symbols «[ ]». If you press
any button in the blocking mode, the display (13) will
show the symbols «[ ]».
• To unlock the control panel, press and hold the button
(16) «+» again, you will hear a sound signal and the
display (13) will show the symbols «][«.
General procedure for using automatic cooking
programs
IMPORTANT! If you are using the appliance to boil
water (e.g. when cooking food), DO NOT set the cooking
temperature above 100 °C. This can lead to overheating
and damage to the multicooker. For the same reason, DO
NOT use the «Frying/Deep-Frying», «Bread» or «Bake»
programs to boil water.
1. Prepare (measure) the required ingredients.
2. Put the ingredients in the bowl (8) following the
instructions in the recipe book or cooking program table (if
you are cooking your own recipe). Make sure
that all ingredients, including liquid, do not exceed the
maximal mark on the inner surface of the bowl (8).
Make sure that the bowl (8) is placed evenly and has a
tight contact with the heating element.
3. Close the multicooker lid (4). In some programs
it is possible to cook with the lid (4) open, follow the
instructions in the recipe book.
ATTENTION! If you cook at high temperature with a lot
of
vegetable oil, always leave the multicooker lid (4) open.
4. Insert the power cord (35) jack into the socket (7).
5. You will hear a sound signal, and the multicooker will
switch to the standby mode, the display (13) will show
the symbols «– – – –».
6. Select the desired cooking program by pressing
the button (16) «+» or (17) «-». The programs are
switched on a loop, while the display (13) will show
the digital symbols of the cooking time set by default
(see“Automatic cooking program table”), one of the
indicators of the automatic cooking program (21-30) will
light up (except for the cooking program for rice and
uy porridges with water (10) «
»), the indicator of
the button for turning on the cooking program, automatic
heating on/o (15) «
» will ash.
7. If necessary, you can change the default cooking time
(see section «Setting the cooking time»). When you
select the «Multicook» program, you can also change
the cooking temperature (see section «Setting the
To Next Page
Loading...
