11
the minute-by-minute countdown of the cooking time on
the display (13) will start immediately or when the required
temperature in the bowl (8) is reached.
In some automatic programs the countdown of the preset
cooking time will start only after the unit reaches the preset
operation parameters. It is accompanied with a sound
signal. For instance, in the «Steam cooking» program the
countdown will only start after the water has boiled and
there is enough steam in the bowl (8).
10. After the cooking/auto-heating program is nished, the
display (13) will show “End” for a few seconds, then the
multicooker will switch to the standby mode.
To cancel the set program or stop the cooking/auto-heating
process, press the button (11) «
».
Table of automatic cooking program default settings
(factory settings) (page 12)
cooking temperature in the Multicook program»).
8. If necessary, set the delayed start time (see the chapter
«Delayed start»).
When you set the cooking parameters, changed digital
values will be ashing on the display (13).
If you didn’t make any additional settings in 5 seconds, the
changed program settings will be saved automatically.
Pressing the heating on/o, cooking stop, reset (11) «
», while setting the cooking program parameters before
automatic saving, will switch the multicooker to the
automatic cooking programs selection mode.
Press the heating on/o, cooking stop, reset (11) «
»
again to switch the multicooker to the standby mode.
After 1 minute of inactivity during setting the cooking
program, the multicooker will switch to the standby mode.
At any stage of the setting, pressing the cooking program
start, auto-heating on/o (15) «
» will start the cooking
program with the current settings. Unchanged parameters
will stay with default settings.
9. To start the cooking program, press and hold the
cooking program start, auto-heating on/o button (15) «
». During the program operation the selected program
(21-30) indicator and the buttons (11) «
» and (15) « »
indicators will be glowing.
If the auto-heating function is active, the indicator (19) «
» will glow. Depending on the selected cooking program,
To Next Page
Loading...
