23
• With regular use of the bowl (8), a complete or partial
discoloration of
• its inner non-stick coating is possible, it is not
covered by warranty.
Cleaning the process chamber
• Avoid getting liquid, food particles or foreign objects
into the process chamber of the multicooker, in
order to avoid improper operation or breakage of the
multicooker.
• If the process chamber or heating element has
nevertheless become dirty, it is necessary to clean
the inner surface of the process chamber and the
heating element.
• Clean the surface of the heating element and the
temperature sensor, which is located in the middle
of the heating element, with a slightly damp cloth or
sponge, then wipe the heating element dry. When
using detergent, it is necessary to carefully remove
its residues in order to exclude the appearance of an
undesirable odor during subsequent cooking.
• Always monitor the mobility of the temperature
sensor, if foreign bodies get in, carefully remove them
with tweezers, do not press hard on the temperature
sensor casing.
STORAGE
• Before taking the multicooker away for long storage,
unplug it and let the unit cool down.
• Clean the multicooker.
• Keep the multicooker out of reach of children and
disabled persons.
BEFORE APPLYING TO THE SERVICE CENTER
Malfunction Possible causes Solution
A system error
message has
appeared on the
display: Е*.
System error, possible
failure of the control board
or heating element.
Unplug the unit
from the mains and
let it cool down.
Connect the unit to
the mains again.
The multicooker is
not switched on.
The multicooker is not
connected to the socket.
Make sure that
the multicooker is
connected to an
operating socket.
The mains socket is
malfunctioning or there is
no voltage in the mains.
The food cooking
takes too long.
A foreign object or particles
(garbage, cereals, pieces of
food) have gotten between
the bowl and the heating
element.
Unplug the
multicooker and
let it cool down.
Remove the
foreign object or
particles from the
heating element.
The bowl is not installed
properly in the unit body.
Install the bowl
evenly.
To Next Page
Loading...
