BRAYER BR2801 - Voltage and Power Monitoring; Maintenance and Troubleshooting; Overheating Protection; Cleaning and Care

10 EN
(7) «-/+» you can set the delay time from «0:00 to
24:00» hours.
Notes:
- If you have not made any settings within 5
seconds, the unit will return to the original mode.
- in the cooker operating/deactivation time setting
mode press the buttons (7) «-/+» shortly to
decrease or increase the time by 1 minute;
- press and hold the buttons (7) «-/+» shortly to
decrease or increase the time by 10 minutes;
«Voltage» button
• To determine the power consumption during the
cooker operation, press the button (5) «Voltage»
« » once, the display (9) will show the power
consumption in kilowatts per hour (kWh).
• Press the button (5) «Voltage» « » again, the
display (9) will show the mains voltage at that
moment.
• Press the button (5) «Voltage» for the third time
to exit the function of determining the consumed
electricity and voltage measurement.
• To switch the cooker o󰀨, press again the button
(11) «On/O󰀨» « », the button (11) «On/O󰀨» « »
indicator will go out. Wait until the cooling fan stops
rotating and disconnect the power plug (3) from the
mains socket.
Notes:
- the control buttons are sensory, you just have to
touch it;
- each pressing of the control button is
accompanied with a sound signal;
- after switching the electric cooker o󰀨, the cooling
fan will continue to run for some time, do not
disconnect the power plug (3) from the mains after
the cooling fan has stopped spinning.
OVERHEATING PROTECTION
• The cooker is equipped with overheating protection
system. If the empty cookware is heated, the
overheat protection system will activate, you will hear
sound signals, the display (9) will show the «E5»
symbol, and the electric cooker will automatically
switch o󰀨.
• If it happens, switch the cooker o󰀨 and wait until it
cools down before switching it on again.
CLEANING AND CARE
• Switch the cooker o󰀨 by pressing the button (11)
«On/O󰀨» « », wait until the cooling fan stops
spinning and disconnect the power plug (3) from the
mains.
• Wipe the cooker body surface with a slightly damp
cloth and then wipe it dry.
• Use the glass ceramic cleaners to clean the hob (2).
• Do not use metal sponges, abrasives or solvents to