HOW TO USE
Take your Breeo Base out of the box and remove it from
the bag. Position it where you’d like your re pit.
Once the Base is situated, place your re pit on the Base
with the legs aligned with the corners of the base.
Once the re pit is placed on the Base, do not slide the
Base across the surface as it may scratch your surface.
Also, sliding the re pit on the Base should be avoided as
it could scratch it.
SURFACES
Non combustible surfaces:
The Breeo Base will protect paver patios, stamped
concrete, concrete, blacktop, gravel, dirt & any other non
combustible surfaces from damage due to excessive heat.
Combustible surfaces:
The Breeo Base will provide adequate protection from
damage due to excessive heat on wood decks, composite
decks, and wood chips. However, due to the combustible
nature of the surface, a spark screen is required at all times
and the rewood must stay below the rim of the re pit at
all times.
Grass:
The Breeo Base can be used on grass to add extra height
to your re pit, but it will not provide adequate protection
to prevent the grass from dying due to heat.
Scan the QR code to
watch an FAQ video
about the Breeo Base.
HOW TO USE THE
BREEO BASE
To Next Page
Loading...
