SETTING UP YOUR
ANCHORPOINT™
GRILLING WITH
YOUR ANCHORPOINT
OR FIRE PIT
STEP 1
Choose where you would like
to set up your Outpost™ grill.
Be sure to have stabilizing
bars perpendicular to your re.
STEP 2
Insert the end of the post
opposite the locking
mechanism into the
Anchorpoint™ system
sleeve. Using the other end
can damage the locking
mechanism.
STEP 3
Using the post*, pound
the Anchorpoint system into
the ground. Be sure to keep
sleeve and post vertical
for maximum stability.
*Do Not Use A Hammer
STEP 4
Continue pounding until
the entire spearpoint and
stabilizing bars are fully
submerged in the ground.
STEP 1
Insert the locking mechanism
end of the post into the sleeve
on your re pit or
Anchorpoint™ system.
STEP 2
Align pegs with notches,
lower post, & twist to lock.
STEP 3
Slide locking collar into place
to lock the post into place.
Post is positioned correctly
when locking collar slides
down into lock mechanism.
STEP 4
Slide the grill down the post
and tighten fastener at desired
height. Before rst use, cure
empty grill over hot re for
3-5 minutes. Enjoy!
To Next Page
Loading...