Breitling AEROSPACE B70 - ALARM; Usage; Setup

AEROSPACE
CHRONOMETER
A
C
B
AL1 OFF
HH:MM:SS
36 37
ALARM
Browse through the dierent functions until the upper
display shows [AL1 OFF/ON] or [AL2 OFF/ON]
Usage
• The watch has two independent alarms. The upper
display will either show [AL1 OFF/ON] or [AL2 OFF/ON].
• The upper display will show [AL1 OFF] if the alarm is
turned o and [AL1 ON] if the alarm is turned on,
• In AM/PM mode, the lower display will show the alarm
time setup [HH:MM:PM] if the alarm is set for PM and
[HH:MM:AM] if the alarm is set for AM.
• When in alarm mode, press A to set the alarm displayed to ON or OFF.
• When in alarm mode, press C to switch between alarms 1 or 2.
Setup
• Press B until the upper display shows [ALARMX] and the lower display
flashes [HH:MM: ].
• Press B. In AM/PM mode, the upper display will show [AL1 AM] or [AL1 PM].
Press A or C to choose either AM or PM for the alarm time. If you had previously
selected the 24h format for the main time display, please note that this step
is not relevant.
• Press B. The lower display [HH:MM ] will start flashing. Press A to increase
the number or C to decrease the number.
• Press B to validate and set up the next number. [HH:MM ] will start to flash.
Please repeat this operation until all numbers are set.
• Press B once all numbers are set. The lower display will flash and display
the alarm setup.
• Press B to confirm the setting.
Nota bene
H for hours / M for minutes