brel-motors MLE Series

To Next Page

Page 1

BREL motors is part of:

Manual Brel Radio Tubular motor

Type MLE

Read the manual before you begin the installation. If these instructions are not followed,

this may lead to defects and injury in which warranty can’t be claimed.

warning:

Children cannot recognize the dangers of electrical equipment and may therefore not work with it.

It is important to follow this instruction for your own safety.

1. Do not operate the motor in humid surroundings.

2. The motor must be installed correctly.

3. Keep the antenna in a good condition and do not shorten. The antenna should not come into contact

with other metal parts otherwise it will reduce the effect.

4. The motor must be protected from direct moisture influences.

_______________________________________________________________________________

Functions remote control

Works with all BREL transmitters:

__________________________________________________________________________________

Technical data of the motor MLE15-0.3 MLE16-0.3 MLE25-1.1 MLE28-2 MLE35-3 MLE35-10

• Motor voltage: DC 8V DC 8V DC 8V DC 12V DC 12V DC 12V

• Charge voltage: DC 5V DC 5V DC 5V DC 5V DC 12.6V DC 12.6V

• Maximum ampere charger: 2 A 2 A 2 A 2 A 2 A 2 A

• Power: 5 W 3.6 W 8 W 15 W 26 W 26 W

• Torque: 0.3 Nm 0.3 Nm 1.1 Nm 2 Nm 3 Nm 10 Nm

• Speed: 30 rpm 50 rpm 28 rpm 28 rpm 28 rpm 9 rpm

• Amperage: 0.6 A 0.78 A 0.94 A 1.25 A 2.20 A 2.20 A

• Moisture and dust: IP44 IP44 IP44 IP44 IP44 IP44

• Storage capacity is up to 20 channels:

• Working temperature of the motor:

o Heavy use: -10℃ tot +40℃

o Normal use: -20℃ tot +70℃

______________________________________________________________________________

Reach L1 = 100 meter L2 = 25 meter

Need help?

Do you have a question about the brel-motors MLE Series and is the answer not in the manual?

Summary

Functions remote control

Technical data of the motor

Motor Installation and Configuration

Initial Channel Setup

Guides the initial channel setup and motor programming for the first channel.

Change motor direction

Details how to set the correct rotation direction for the motor.

Setting the end limits

Explains how to configure the top and bottom travel limits for the motor.

Setting third limit position

Describes how to set an additional third limit position for specific uses.

Additional Settings and Operations

Delete limit position

Instructions for removing previously set motor limit positions.

Teaching multiple transmitters

Procedure for pairing multiple remote transmitters with the motor.

Delete all channels

How to remove all paired transmitters and settings from the motor.

Pulse setting

Configuration for the pulse mode operation of the motor.

Pairing new remote with end limits

How to pair a new remote while keeping existing end limits intact.

Speed control

Adjusting the motor's operating speed to different levels.

Reset everything

Procedure to perform a full factory reset on the motor.

Adjusting the top position

Guide on setting the new upper limit position for the motor.

Adjusting the bottom position

Guide on setting the new lower limit position for the motor.

Disable receiver

Instructions on how to temporarily turn off the motor's receiver.