EasyManua.ls Logo

Bremont U-2 - Changing the Strap; Winding the Watch

Bremont U-2
43 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
U-2/U-22
AUTOMATIC CHRONOMETER
Your Bremont watch shows you the time in hours, minutes and seconds,
and the day and date. The mechanical movement with automatic winding
has a free-swinging rotor that keeps the mainspring wound via the motion
of your wrist. The movement in your U-2/U-22 has 25 jewels, runs at
28,800 bph and has a 38-hour power reserve once fully wound. The watch
is water resistant to 100m (10ATM) and the dial is protected by a dual anti-
reflective sapphire crystal that is retained securely in the case.
To ensure that this rather special watch continues to run beautifully for
years to come you must follow a few important operating instructions...
winding The waTCh
Your U-2/U-22 can be wound from crown position I by rotating the crown
in a clockwise motion. The movement will automatically start with just a
few revolutions of the rotor, however it is better to wind the movement
fully with 30-40 revolutions of the crown. By doing this you will achieve
maximum accuracy and have a power reserve of 38-hours, even when the
watch is not on your wrist.
Changing The sTraP
REMOVING A STRAP
Use the end of your watch tool to
carefully lever the spring bar out
of the lug.
FITTING A STRAP
Place one end of the spring bar
into the hole in the lug and use the
end of the watch tool to lever the
other end into position.

Related product manuals