To Next PageTo Next PageWhat to do if my brennenstuhl RM L 3100 Smoke Alarm keeps beeping every 40 seconds?
If your brennenstuhl Smoke Alarm beeps every 40 seconds due to an error, you can temporarily deactivate this message for 10 hours by pressing the test button. However, the device must be replaced immediately.
Why does my brennenstuhl RM L 3100 Smoke Alarm LED flash every 40 seconds and beep?
If your brennenstuhl Smoke Alarm's LED flashes once every 40 seconds, accompanied by beeping, it indicates that the integrated battery is weakening. You can temporarily stop the beeping for 10 hours by pressing the test button. However, the smoke alarm must be replaced immediately.
Why is my brennenstuhl Smoke Alarm beeping and the LED flashing every 10 seconds?
If the LED on your brennenstuhl Smoke Alarm flashes once every 10 seconds and beeps, this indicates that the product has reached the end of its lifespan and the device must be replaced immediately.
What to do if my brennenstuhl RM L 3100 Smoke Alarm has a continuous, pulsating tone?
If your brennenstuhl Smoke Alarm emits a continuous, pulsating tone and the LED flashes once per second, you should leave the danger zone immediately. If you were testing the device, release the test button.
How to stop brennenstuhl RM L 3100 Smoke Alarm from beeping three times?
Releasing the test button will stop the brennenstuhl Smoke Alarm from beeping three times every 1.5 seconds.
What does it mean when the LED flashes once every 40 seconds on brennenstuhl RM L 3100 Smoke Alarm?
When the LED flashes once every 40 seconds on your brennenstuhl Smoke Alarm, it indicates that the smoke detector is working properly.
Why is the LED on my brennenstuhl RM L 3100 Smoke Alarm flashing once every 8 seconds?
The brennenstuhl Smoke Alarm is de-sensitised for approximately 10 minutes when the LED flashes once every 8 seconds.
General| Type | Optical smoke alarm |
|---|---|
| Power Supply | 9V battery |
| Test Button | Yes |
| LED Indicator | Yes |
| Operating Temperature | 0°C to +40°C |
| Standby Current | 10 µA |
| Alarm Volume | 85 dB at 3 meters |
