10. thoroughly rinse ice-cube chute, evaporator cover panel, sprayer bank and the corresponding
side caps, overflow pipe and sprayer bank feed pipes under running water
11. refit parts previously removed
12. reposition front panel of appliance and secure with screws
13. reposition top and secure with screws
14. remove right-hand side panel by removing lower screws and extracting it from its seating (Fig. 3)
15. press washing pushbutton (1 in Fig. 3) and refit right-hand side panel by tightening fixing
screws
The ice-cube maker can now be reactivated as specified in the instruction book.
‼
IMPORTANT: All the ice produced during the first five cycles after cleaning and
sanitizing operations must be discarded.
When the appliance is cleaned and sanitized, its bin must also be cleaned and sanitized.
THE FOLLOWING ADDITIONAL OPERATIONS ARE REQUIRED FOR SOME PARTICULAR
MODELS:
4 MODEL WITH DAILY PRODUCTION OF 750 kg
To access the washing pushbutton (1), remove the front right-hand panel located above the
condenser (Fig. 7).
To access the evaporators, remove the front left-hand and rear left-hand panels by unscrewing
the fixing screws and lifting them to release them; then remove the left-hand part of the top by
lifting it from the framework of the appliance (Fig. 8).
Repeat the operations described in chapters 2 and 3 on the front and rear evaporators.
At the end of the cleaning and sanitizing operations on the appliance, reposition the panels
previously removed, and tighten the fixing screws.
To Previous Page
Loading...