k. BrandMeister Network ESSID: If you are
using multiple hotspots that you want to
treat independently, this allows you to use a
single DMR ID to accomplish this. If this is
the only hotspot you plan on using, leave
this set to None.
l. Enable and configure the other DMR
networks you plan on using. BrandMeister is
currently the largest DMR network, and
currently the only network we offer direct
support on configuring. Information on
configuring other DMR networks can be
found on their respective websites.
m. DMR Color Code: Unless you are using a
code plug configured to a different color
code, leave this set to 1.
n. Node Type: In most cases, this should be set
to Private. If you want to share this hotspot
with others, you will need to enter a
comma-separated list of all the DMR IDs in
the DMR Access List box and click Apply
Changes. Then you can set the Node Type
to Public. This precaution is put in place to
prevent network loops.
To Next Page
Loading...