Briel CHAMONIX ES35 - Espresso Flow and Coffee Temperature; Frothing Milk Issues; Machine Operation Issues

* This must be done in an authorized service facility only.
P
32
ossible Causes SolutionProblems
· The Espresso flows too slowly or not at
all.
· Very fine grind; · Try another coffee brand for espresso;
· Adjust the grinder level to a coarser
grind (between level 2 and 3);
· There are coffee remaining in the
brew-head;
· Clean the brew-head;
· Descale the machine as described in
the instructions manual;
· There is calcareous in the machine;
· Check out if the water tank is filled
and correctly placed;
· There is no water flow and the pump
is abnormally noisy;
· Verify pressure / replace pump *;· Insufficient pressure
· The coffee is not hot enough; · The machine has not pre-heated
enough time;
· Verify the temperature lamp;
· Place the filter-holder without coffee
in the machine as it pre-heats, so that
the filter-holder can also heat;
· Allow some water to flow through the
filter-holder, so that it can get warm;
· Cold cups · Pre-heat the cups with the steam
nozzle;
· Verify / replace thermostat *;
· Verify / replace resistance *;
· Low temperature water flows from
the brew-head;
· Clean the steam nozzle;· You cannot froth the milk. · The nozzle is obstructed;
· Use a tall, narrow container, preferably
metal.
· Inadequate recipient;
· Inadequate milk; · Use cold whole milk, preferably low
fat milk;
· This is a normal procedure;
· Allow water to flow and place the
recipient only as steam starts;
· Waters flows before steam;
· No steam; · Press the steam button (when
applicable) until the temperature lamp
lights;
· Verify / replace thermostat *;
· Verify / replace resistance *;
· The boiler does heat when you press
the steam button;
· Wait for 15 seconds before removing
the filter-holder;
· When removing the filter-holder, make
some lateral pressure to let the filter
or pod fall;
· You did not wait for 15 seconds before
removing the filter-holder;
· The pod or the filter are gripped in the
machine;
· Check the connections;· The machine is not working at all; · Incomplete connections;
· The machine ran out of water and the
safety system has been triggered;
· Wait 30 min. before using the machine
again;