EasyManua.ls Logo

Briggs & Stratton 243431 User Manual

Briggs & Stratton 243431
6 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Question and Answer IconNeed help?

Do you have a question about the Briggs & Stratton 243431 and is the answer not in the manual?

Briggs & Stratton 243431 Specifications

General IconGeneral
Fuel TypeGasoline
Cylinder1
Starter TypeRecoil
Engine Type4-Cycle OHV
Power Output4.5 HP
Horsepower4.5 HP
Ignition SystemElectronic
Spark Plug Gap0.030 in

Summary

Before Starting

Fill Crankcase with Oil

Instructions for filling the engine's crankcase with the correct type and amount of oil.

Fill Fuel Tank

Guidance on using clean, fresh, lead-free or leaded regular grade automotive gasoline.

Starting the Engine

Open Fuel Valve

Procedure to open the fuel valve before starting the engine.

Close the Choke

Instructions on closing the choke for starting, manual or remote.

Start Engine

Details on starting the engine using a rope starter or electric starter.

To Stop Engine

Method for stopping the engine using the stop switch or ignition switch.

Maintenance Procedures

Check Oil Level

How to check the oil level before starting and after 5 hours of operation.

Change Oil

Procedure for changing engine oil after initial 5 hours and then every 25 hours.

Servicing Heavy Duty Air Cleaner

Steps for cleaning and re-oiling foam pre-cleaner and paper cartridge.

Clean Cooling System

Guidance on cleaning cooling fins to prevent overheating.

Clean Combustion Chamber

Instructions for cleaning deposits from the combustion chamber every 100-300 hours.

Additional Maintenance and Adjustments

Clean and Adjust Contact Points

Procedure for cleaning and setting the gap for breaker points.

Clean Spark Plug

How to clean and reset the spark plug gap to 0.030 inches.

Drain Fuel Tank and Clean Fuel Filter

Steps to drain fuel and clean the fuel filter bowl and screen.

Carburetor Adjustments

Guidance on initial and final adjustments for the carburetor.

Adjustments and General Information

Governor Speed Adjustments

How to adjust governor speed for idle and top no-load speeds.

Remote Speed Control Adjustment

Procedure for adjusting engine speed using a remote control lever.

Storage Instructions

Recommendations for storing the engine for over 30 days.

Tune-Up Specifications

Key specifications for spark plug, ignition points, and valve clearances.

Service and Warranty Information

Service & Repair Information

Guidance on contacting authorized service centers for repairs.

Warranty Details

Information regarding the one-year limited warranty for engine parts.