6
Starting
1. Check oil level. Ensure level is at FULL mark on
dipstick. Use a high quality motor oil. Review oil
recommendations for selection of oil grade for
expected starting temperature.
2. Open the fuel shut-off valve, if equipped.
3. Move choke control to CHOKE and speed control to
FAST or RUN.
4. Insert key and turn to START.
Note: To prolong starter life, use short starting
cycles (5 seconds maximum, then wait one
minute). Follow equipment manufacturer’s
recommendations for charging battery.
5. Let engine warm up.
6. Choke Equipped: Move choke control lever toward
RUN a short distance at a time over several
seconds in warm weather or minutes in cold
weather. Let engine run smoothly before each
change.
7. Operate with choke in RUN or OPEN position.
CAUTION
Operation of this engine is for the application it
was intended. All the components used to build
this engine assembly must remain in place for
the proper operation of this engine.
OIL PRESSURE SWITCH
If engine is equipped with an oil pressure switch, read the
operating instructions supplied by the equipment
manufacturer to understand how the switch functions.
Engines give off carbon
monoxide, an odorless, colorless,
poison gas.
Breathing carbon monoxide can
cause nausea, fainting or death.
WARNING
Stopping
1. Move speed control to SLOW, if equipped.
2. Turn key to OFF. Remove key and store out of
reach of children.
3. Close fuel shut-off valve, if equipped.
WARNING
DO NOT stop engine by choking
carburetor. Backfire, fire or engine
damage could occur.
1-800-233-3723
(USA and Canada ONLY, Pre-recorded message.)
www.briggsandstratton.com
Need assistance?
To Next Page
Loading...
Need help?
General
