What to do if my Briggs & Stratton motor will not run?
If your Briggs & Stratton Air Compressor motor won't run, first, allow the motor to cool for 15 minutes, then press the RESET button to reset the overload protector switch. If that doesn't work, the motor will automatically start when the tank pressure drops below the “cut-in” pressure setting.
Why is my Briggs & Stratton Air Compressor not supplying enough air?
If your Briggs & Stratton Air Compressor is not supplying enough air, start by decreasing the amount of air you are using. Ensure that the accessory's requirement is not higher than the CFM or pressure supplied by your air compressor; if it is, you'll need a larger capacity compressor. Inspect the hose for any holes and replace it if needed. Also, clean or replace the air intake filter to ensure it's not restricted.
How to fix air losses in my Briggs & Stratton Air Compressor?
To address air losses in your Briggs & Stratton Air Compressor, begin by tightening any quick connect fittings where you hear air escaping and replace the fittings if necessary. If the problem persists, the air tank must be replaced; do not attempt to repair it.
What to do if the safety valve pops off on my Briggs & Stratton Air Compressor?
If the safety valve on your Briggs & Stratton Air Compressor is popping off due to excessive tank pressure, immediately move the ON - OFF switch to the OFF position.
General| Brand | Briggs & Stratton |
|---|---|
| Model | Air Compressor |
| Category | Air Compressor |
| Language | English |
General safety guidelines and hazard symbol explanations.
Explains common safety symbols and their implications.
Essential steps for safely grounding the air compressor to prevent shock.
Required steps before initial use to ensure proper compressor function and longevity.
How to reset the motor's overload protection feature if it trips.
Instructions for checking and changing the compressor pump oil.
Details the terms, conditions, and duration of the product warranty.
To Next Page
