The filter material of the MAXTRA PRO water filter undergoes a
special treatment with silver for hygiene reasons.
A small quantity of silver may be released into the water. This is in
line with the recommendations of the World Health Organization
(WHO).
BRITA recommends replacing the water filter regularly.
Please follow the recommended cleaning procedures and advice
on preparing the filter (chapters 1 – 7).
The jug should be cleaned regularly.
Note:
If the jug is not being used for a while, remove the water filter,
empty the jug and replace the water filter loosely in the empty
funnel.
Please refer to chapter 7 “Changing the MAXTRA PRO water filter”.
Operation – very easy
TIP
Please make sure to check if all the parts are included before using.
In the event of any defects or damaged components, please refrain
from using and contact the BRITA Customer Center directly.
1
Clean before the first use and every time you change the
water filter
The jug should be cleaned before the first use and when you
change the water filter – the funnel and jug are dishwashersafe
(max. 50° C) or can be cleaned by hand! Please clean your
BRITAFlow only by hand with cold or lukewarm water.
Glass Jug: In general, the Glass Jug sealing rings are dishwasher
proof, but we still recommend washing them by hand. Otherwise,
slight discolouration may occur. Dry it thoroughly before
reattaching it to the funnel.
Lid with BRITA Smart Light
A1
+
A2
Please remove the BRITA Smart Light before cleaning the lid (turn
counter-clockwise).
The BRlTA Smart Light must not be washed in the dishwasher!
Remove the BRITA Smart Light by hand and clean with a soft,
damp cloth.
Lid with non-removable BRITA Memo
J
Please clean the lid by hand, as it is not dishwasher safe!
2
Preparing the MAXTRA PRO water filter
B
Fill the clean jug with cold water.
Immerse the water filter and shake slightly to remove any excess
air. Remove the water filter and pour away the water in the jug.
Done!
To Next Page
Loading...
