Britax Agile Plus - To Fit and Remove Rear Wheels; To Use the Swivel Wheels

www.britax.com.au
9
A To fit the rear wheels, insert each wheel axle into the moulding and push in
until locked. You should hear a ‘click’ which indicates the wheel has locked in.
Pull on the wheel to make sure it is engaged. Repeat the process if not locked
in.
B To remove the wheels, pull the metal latch downwards on the underneath of
the brake moulding to release the wheel, and then pull the wheel off.
A Press the swivel lock down to lock the swivel wheels.
Push the swivel wheel lock up to allow the wheels to swivel.
Note: Always lock the swivel wheels when using the stroller on rough
surfaces as it will minimise wheel wobble.
03. TO FIT AND REMOVE THE REAR WHEELS
04. TO USE THE SWIVEL WHEELS
A B
Metal
Latch