EasyManua.ls Logo

Britax COMPAQ - SUITABLE FOR USE; WARNINGS

Britax COMPAQ
28 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Do not allow the front seat to alter
the installed position of the
restraint.
DO NOT USE RESTRAINT IN REARWARD
FACING MODE WITHOUT STABILISING BAR
FULLY EXTENDED.
Do not use the restraint without the Upper
Anchorage Strap correctly attached.
DO NOT USE CHILD RESTRAINTS IN A
SEATING POSITION WHERE AN AIR BAG IS
FITTED. FOLLOW THE CAR
MANUFACTURER’S RECOMMENDATIONS.
If your vehicle is not fitted with an anchor point,
please contact a Safety Restraint Fitting Station
authorised by the relevant State Government
Body for correct fitment of the restraint. In New
Zealand contact the agent for the vehicle. The
upper anchorage strap must be attached to an
anchorage point using an extension strap if
necessary.
Do not use on any vehicle seat which
faces sideways or rearwards.
When using the restraint in the front
seat, do not use the rear seat. The
upper anchorage strap will need to
pass the rear seating position to attach
to an anchorage point.
To be used only in a rearward-facing
position for a child weighing up to 12kg.
The purchaser should check the measurements
between the front of the seat back of the rear seat and
all front seats in the car in which the child restraint is
intended to be used, to ensure that the space is
sufficient.
In certain vehicles, where the rear seat area is too
restricted, the only position possible for the restraint is on the front seat and
adjusted as rearward as possible (provided no airbag is fitted in this position).
TO BE USED WITH A LAP-SASH OR LAP ONLY SEAT BELT IN THE FRONT OR BACK
OF MOST CARS WITH FORWARD-FACING SEATS.
500 mm
560 mm
Up to 12 kg Facing Rearward
WARNINGS
SUITABLE FOR USE
Rearward Facing (Up to 12 kg)
FOR
BABY
USE
8

Related product manuals