Britax UNITY - Removal of Baby from Infant Carrier

33
HOW TO USE
REMOVAL OF BABY FROM INFANT
CARRIER
A. Rotate the carry handle to either the access or
"non-rocking position" and ensure the Canopy is fully
open.
B. Press the Harness Adjuster while pulling shoulder straps
to loosen the harness.
C. Press the red button on Harness Buckle then both Harness
Tongues will be released. Place Buckle tongues through
Buckle Tongue Holder's (if tted) on each side of the cover
or Padded Insert.
D. Feed the baby’s arms through each side of the Harness and
place the straps on each side of the carrier clear of the baby.
Lift the baby out of the carrier.
Buckle Tongue
Holder (if tted)
NOTE: Once the baby gets heavier you may wish to leave the carrier in the car. In
this case you will need to disconnect or loosen the upper anchorage strap before
removing the baby.
3