Put shoulder straps back into the metal anchor (O) (Fig. 5).
3. ADJUSTING HEADREST
Loosen the red button on back of the headrest in counter-clockwise direction (Fig. 6).
Adjust the headrest height according to the height of your child (Fig. 7).
Tighten the headrest by turning the red button in clockwise direction (Fig. 8).
WARNING! Red button could only be placed on the rectangular groove at the top and bottom of
the headrest (Fig. 9).
4. INSTALLING THE CHILD CAR SEAT FOR GROUP 0 (from birth to 10kg)
Turn the reclining board (M) from back to front (Fig. 10).
Grip recline handle (I) at the front of the child car seat and pull the seat into its fully reclined
position. The seat must be fully reclined when facing rearwards (Fig. 11).
Place the child car seat on a passenger seat facing rearward (Fig. 12).
Put the lap belt under the extra cushion (Fig. 13).
Same time bring the diagonal belt through the belt guide (L) round the back of the seat (Fig.
14).
Check and make sure there is no twist of the belt. Insert the metal tongue of the car belt into
the car seat buckle until you hear a clear ‘click’ (Fig. 15).
Tighten the seat belt by pulling in the direction of the seat belt reel (Fig. 16).
Pull the lap and diagonal belt tightly and attach the belt clip (Q) to the diagonal section of seat
belt. Ensure it’s attached as close as possible to the seat belt buckle without touching it (Fig.
17).
WARNING: Each time you adjust the child car seat, check that it is still secure, the backrest of
the child car seat rests on the vehicles seat and that the seat belt is tight. If there is any slack in
the vehicle seat belt then retighten it before starting your journey.
5. SEATING YOUR CHILD INTO CAR SEAT FOR GROUP 0 (from birth to 10kg)
Loosen the harness by pushing the adjuster button (H) in as you pull the shoulder straps (E)
forward as much as possible (Fig. 18).
NOTE: Pull the harness UNDER the chest pads. DO NOT pull on the chest pads.
Unfasten the harness buckle by pressing the red button and releasing the shoulder straps (E)
(Fig. 19).
Place your child in the child car seat (Fig. 20).
Fit the harness around your child and fasten the harness buckle by joining the shoulder straps
(E) and pushing them both into the buckle (F) (Fig. 21).
Check that the harness is not twisted and pull the harness up to tighten the lap sections which
is designed to t low down on your child’s body.
Pull the adjuster strap (J) forward making sure the harness is a comfortable but FIRM t around
your child (Fig. 22).
Finally, pull both shoulder pads down (C) from your child’s shoulders onto their chest.
NOTE: The shoulder pads are an important safety feature. Never use the car seat without them
6. INSTALLING THE CHILD CAR SEAT FOR GROUP 1 (from 9kg to 18kg)
Grip the recline handle (I) at the front of the child car seat and push the seat into its upright
position (Fig. 23).
Turn the reclining board (M) from front to back (Fig. 24).
Place the child car seat in the forward facing position on the car seat (Pic. 25).
Insert the seat belt tongue into the slot on backrest and pass it through the back of the seat
(Fig. 26).
Check and make sure there is no twists of the belt. Plug the car seat belt tongue securely into
the carseat buckle until you hear a clear ’click’ (Fig. 15).
Tighten the seat belt by pulling in the direction of seat belt reel (Fig. 27).
To Next Page
Loading...