EN
Pull the lap and diagonal seat belt tightly and attach the belt clip (Q) to the diagonal section of
the seat belt. Ensure you attach it as close as possible to the seat belt buckle without touching
it (Fig. 17).
7. SEATING YOUR CHILD INTO CAR SEAT FOR GROUP 1 (from 9kg to 18kg)
Pull recline handle (I) to the position you want. Then check if the position is xed and locked to
avoid any potential danger (Fig. 28).
Loosen the harness by pushing the adjuster button (H) in as you pull the shoulder straps (E)
forward as much as possible (Fig. 29).
NOTE: Pull the harness UNDER the chest pads. DO NOT pull on the chest pads.
Unfasten the harness buckle by pressing the red button and releasing the shoulder straps (E)
(Fig. 19).
Place your child in the child car seat (Fig. 30).
Fit the harness around your child and fasten the harness buckle by joining the shoulder straps
(E) and pushing them both into the buckle (F) (Fig. 21).
Check that the harness is not twisted and pull the harness up to tighten the lap sections which
is designed to t low down on your child’s body.
Pull the adjuster strap (J) forward making sure the harness is a comfortable but FIRM t around
your child (Fig. 31).
Finally, pull both shoulder pads down (C) from your child’s shoulders onto their chest.
NOTE: The shoulder pads are an important safety feature. Never use the car seat without them
8. INSTALLING THE CHILD CAR SEAT FOR GROUP 2 (from 15kg to 25kg)
Loose the shoulder straps according to Figure 29.
Unhook the shoulder straps (E) from metal anchor (O) (Fig. 3).
Pull out the shoulder straps from the shoulder pads (Fig. 32).
Pull the shoulder straps out from the strap slots of the seat (Fig. 33).
Open the buckle according to Figure 19.
Take off the extra cushion from the seat (Fig. 34).
Get both buckle latches out from the shoulder straps (Fig. 35).
Place the child car seat into reclining position, slide the metal plate which is used to fasten the
harness buckle to the seat shell up on its edge through the strap slot (Fig. 36).
Take both the harness buckle and crotch pad from the seat (Fig. 37).
NOTE: It is suggested that the two buckle latches are inserted into the harness buckle to avoid
missing (Fig. 38).
Undo all Velcro on the main cover and remove the cover (Fig. 39).
Insert both shoulder straps through the belt slot on the backrest and guide the end in metal
anchor (O). Then press the harness adjust button (H) to tight the harness (Fig. 40).
Put the harness adjust strap (J) atly on the seat. Then put the cover on the seat (Fig. 41).
Click the red belt clip to the shoulder straps on the back of the backrest (Fig. 42).
9. SEATING YOUR CHILD INTO CAR SEAT FOR GROUP 2 (from 15kg to 25kg)
Pull recline handle (I) to the position you want. Then check if the position is xed and locked to
avoid any potential danger (Fig. 28).
Place your child in the child car seat (Fig. 43).
Guide the diagonal belt through the belt guide on the headrest and lap belt on child’s abdomen
(Fig. 44).
Check and make sure there is no twist of the belt. Insert the metal tongue of car belt into the
car seat buckle until you hear a clear ’click’ (Fig. 15).
Warning! Make sure your child arms are above both diagonal and lap belt (Fig 44).
10. REMOVING THE COVERS FOR CLEANING
Remove the harness system, shoulder pads and crotch pad according to steps in 8.
To Next Page
Loading...