Need help?Do you have a question about the Brivo ACS300-A and is the answer not in the manual?
General| Brand | Brivo |
|---|---|
| Model | ACS300-A |
| Category | Controller |
| Language | English |
Details FCC Part 15B Class A compliance, operational conditions, and interference correction measures.
States FCC limits for RF radiation exposure and co-location restrictions.
Mentions EN 55032 Class A compliance and potential radio interference warnings.
Outlines UL 294 Standard compliance and specific restrictions for Ethernet, monitoring, Wi-Fi, and Bluetooth.
Presents a table of UL294 performance levels for the ACS300, including security, attack, endurance, and power.
Explains the manual's purpose: providing installation instructions for trained technicians, IT personnel, and dealers.
Describes the manual's organization into procedural checklists for installation phases.
Defines key terms used in the manual, such as Control Panel, ACS, Brivo OnAir, and Brivo OnSite.
Explains the capabilities and communication methods of the ACS300-E, ACS300-A, and ACS300-S variants.
Details compatibility with standard reader models and Wiegand/OSDP protocols, and where to find updated lists.
Instructions to check IT department requirements, LAN compatibility, and download necessary guides.
Crucial safety warning about consulting fire officials before installing locks on fire exits.
Safety warning against using Fail Secure mode without local authority permission due to potential interference.
Details three methods for physically mounting the ACS300 enclosure to walls or junction boxes.
Instructions for connecting an external physical tamper switch to the ACS300, including jumper placement.
Steps to connect the LAN/PoE cable and check power indicators like LEDs for correct operation.
Critical warning about not powering electronic strikes/latches from the ACS300's power source.
Explains how to connect a laptop via Ethernet for local administration, debugging, and configuration.
Instructions to verify the LAN connection, referencing specific admin guides for network setup.
Instructions for wiring Auxiliary Inputs 1 and 2 for contact closure type inputs, used for various purposes.
Specific wiring instructions for connecting Wiegand readers to the ACS300 board.
Specific wiring instructions for connecting OSDP RS-485 readers to the ACS300 board.
To Next Page
