Need help?Do you have a question about the Brivo ACS300-E and is the answer not in the manual?
General| Model | ACS300-E |
|---|---|
| Max Doors | 2 |
| Max Readers | 4 |
| User Capacity | 10, 000 |
| Events | 50, 000 |
| Wi-Fi | No |
| Humidity | 0% to 95% non-condensing |
| Lock Outputs | 2 |
| Auxiliary Outputs | 2 |
| Supported Readers | Wiegand, OSDP |
| Certifications | UL294, FCC, CE |
| Type | Controller |
| Communication | Ethernet |
| Input Voltage | 12 to 24 VDC |
| Operating Temperature | -40°C to 70°C |
| Inputs | 4 |
| Outputs | 2 relays |
| Reader Interfaces | 4 |
Explains ACS300 models (E, A, S), their communication, and compatible reader models.
Checks IT department compatibility, LAN connection requirements, and Quick Start Guide.
Guidance on calculating distances for readers/keypads and placement relative to locks.
Covers fire code compliance and restrictions on using Fail Secure mode.
Advises against installing the panel in extreme temperatures or near noisy electrical equipment.
Details three methods for mounting the ACS300 enclosure using bolts or junction boxes.
Warns against connecting the transformer to switched outlets or before all wiring is complete.
Details using 18 AWG wire to connect the transformer to the ACS300 power input terminals.
Pre-powering checks and instructions for powering up the ACS300 via LAN/PoE.
Warns against powering strikes/latches with ACS300 power to prevent damage.
Explains default Half-Duplex setting, switching to Full-Duplex, and termination requirements.
Instructs to install the supplied MOV for noise suppression near electric strike/latch.
To Next Page
