WARNING: Heat and Noise
DO NOT INSTALL THE CONTROL PANEL IN AN AREA THAT COULD
DROP BELOW 32 DEGRESS FAHRENHEIT OR EXCEED 120 DEGREES.
Doing so can cause damage to components within the control panel.
DO NOT INSTALL THE CONTROL PANEL NEAR OR ON THE SAME
CIRCUIT WITH DEVICES THAT PRODUCE LARGE AMOUNTS OF
ELECTRICAL NOISE. This includes grinders, electric motors and blowers,
electrical switch-gear and other electrically noisy equipment. Electrical noise
can interfere with panel operation. If it is not possible to install the panel
away from such sources of noise, it is advisable to isolate it by using a high-
quality UPS (Uninterruptible Power Supply) between the AC Mains and the
transformer.
• This product is not intended for outside wiring as covered by Article 800 in the National Electrical
Code, NFPA 70.
• Unit is for indoor use only.
• Power wiring attached to the ACS300 unit should be 26 AWG or larger.
• Category 5 cabling is the minimum performance category recommended.
• Do not connect to a receptacle controlled by a switch.
• Compliance with IEEE 802.3 (at or af) specifications was not verified as part of UL294/B.
• UL testing on the ACS300 powered by ITE Listed PoE Injector manufactured by Altronix, model
Netway 1X and a plug-in transformer manufactured by Yeo Heung Electronics Co. LTD., model
SEP/P-2450U.
To Next Page
Loading...