e-mail: support@broadcasttools.com voice: 360.854.9559 fax: 866.783.1742
3
Universal 4.1 MLR»Web Installation and Operation Manual
INTRODUCTION
INTRODUCTION
Thank you for your purchase of a BROADCAST TOOLS® UNIVERSAL 4.1 MLR
>> WEB transparent four input, single output switcher/router (referred to as the
UNIVERSAL 4.1 MLR >> WEB throughout this manual). We’re confident that this
product will give you many years of dependable service. This manual is intended to
give you all the information needed to install and operate the BROADCAST
TOOLS® UNIVERSAL 4.1 MLR >> WEB.
SAFETY INFORMATION
Only qualified technical personnel should install the UNIVERSAL 4.1 MLR >>
WEB. Any attempt to install this device by a person who is not technically quali-
fied could result in a hazardous condition to the installer or other personnel or dam-
age to the UNIVERSAL 4.1 MLR >> WEB or other equipment. Please ensure that
proper safety precautions have been taken before installing this device. If you are
unfamiliar with this type of equipment, please contact a properly qualified engineer
to handle the installation and setup of the UNIVERSAL 4.1 MLR >> WEB.
Broadcast Tools, Inc., is unable to support NON-Broadcast Tools software, hardware
or NON-Broadcast Tools computer/hardware/software problems. If you experience
these problems, please research your hardware/software instruction manuals or con-
tact the manufacturers technical support department.
WHO TO CONTACT FOR HELP
If you have any questions regarding your product or you need assistance, please con-
tact your distributor from whom you purchased this equipment. If you would like
more information about BROADCAST TOOLS® products, you may reach us at:
Broadcast Tools, Inc.
131 State Street
Sedro-Woolley, WA 98284-1503 USA
Voice: 360.854.9559
Fax: 866.783.1742
Internet Home Page: www.broadcasttools.com
E-mail:support@broadcasttools.com
THANK YOU FOR CHOOSING
BROADCAST TOOLS® BRAND PRODUCTS!
CAUTION!
Broadcast Tools®
Products, as with any
electronic device, can
fail without warning.
Do not use this product
in applications where a
life threatening condition
could result due to failure.
NOTE:
This manual should be
read thoroughly before
installation and operation.
WEBSITE:
Visit our web site for
product updates and
additional information.
Designed, Assembled and Tested
in Washington State, USA.
To Next Page