Broan 360NDK - User Manual

To Next Page

1. Install PM390SSP per installation instructions shipped with power module.

2. Remove aluminum filter and attach the CHARCOAL FILTER (included) to the backside of the

aluminum filter with the 4 supplied metal clips.

3. Remove backdraft damper. (Damper supplied with power module.)

4. Cut hole in bottom of SOFFIT to allow clearance for the 90° ANGLE BOOT.

5. Locate top of 4¼” X 10¼” OPENING on soffit - centered on POWER MODULE CENTERLINE and

26.625” above bottom of POWER MODULE.

6. Layout 4¼” x 10¼” pattern and cut opening in soffit.

7. Connect 90° ANGLE BOOT to 6-IN. TO 7-IN. ROUND TRANSITION.

8. Insert boot end into soffit and connect 6-in. round end to the exhaust of the unit.

9. Install GRILLE (included - not shown) into soffit opening.

10. Use metal foil tape to make all connections secure and air tight.

INSTALLATION INSTRUCTIONS

360NDK DUCTLESS CONVERSION KIT FOR THRU SOFFIT VENTING

FOR USE WITH PM390SSP POWER MODULE

SOFFIT

CABINET

90° ANGLE BOOT

(included)

6-IN. TO 7-IN.

ROUND TRANSITION

(included)

PM390SSP

POWER MODULE

OPTIONAL METAL LINER

(LB30SS or LB36SS)

(purchase separately)

4¼” x 10¼”

SOFFIT OPENING

POWER MODULE

CENTER LINE

26.625”

CHARCOAL FILTER

(included) (99010464)

Need help?

Do you have a question about the Broan 360NDK and is the answer not in the manual?

Broan 360NDK Specifications

General