Broan EVOLUTION 3 - User Manual

QP3 SERIES
Page 1
WARNING
CAUTION
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR IN-
JURY TO PERSONS, OBSERVE THE FOLLOWING:
1. Use this unit only in the manner intended by the manufacturer.
If you have questions, contact the manufacturer at the ad-
dress or telephone number listed in the warranty.
2. Before servicing or cleaning unit, switch power off at service
panel and lock the service disconnecting means to prevent
power from being switched on accidentally. When the service
disconnecting means cannot be locked, securely fasten a
prominent warning device, such as a tag, to the service panel.
3. Installation work and electrical wiring must be done by a qual-
ified person(s) in accordance with all applicable codes and
standards, including fire-rated construction.
4. Sufficient air is needed for proper combustion and exhaust-
ing of gases through the flue (chimney) of fuel burning equip-
ment to prevent backdrafting. Follow the heating equipment
manufacturer’s guideline and safety standards such as those
published by the National Fire Protection Association (NFPA),
and the American Society of Heating, Refrigeration and Air
Conditioning Engineers (ASHRAE), and the local code au-
thorities.
5. This product may have sharp edges. Be careful to avoid cuts
and abrasions during installation and cleaning.
6. When cutting or drilling into wall or ceiling, do not damage
electrical wiring and other hidden utilities.
7. Ducted fans must always be vented to the outdoors.
8. Use only metal ductwork.
9. Do not use this fan with any solid-state speed control device.
10. As an alternative, this product may be installed with the UL-
approved cord kit designated for the product, following in-
structions packed with the cord kit.
11. This unit must be grounded.
TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE:
1. Never leave surface units unattended at high settings.
Boilovers cause smoking and greasy spillovers that may ig-
nite. Heat oils slowly on low or medium settings.
2. Always turn hood ON when cooking at high heat or when
flambéing food (i.e. Crêpes Suzette, Cherries Jubilee, Pep-
percorn Beef Flambé).
3. Clean ventilating fans frequently. Grease should not be al-
lowed to accumulate on fan or filter.
4. Use proper pan size. Always use cookware appropriate for the
size of the surface element.
TO REDUCE THE RISK OF INJURY TO PERSONS IN THE
EVENT OF A RANGE TOP GREASE FIRE, OBSERVE THE
FOLLOWING:*
1. SMOTHER FLAMES with a close-fitting lid, cookie sheet, or
metal tray, then turn off the burner. BE CAREFUL TO PRE-
VENT BURNS. If the flames do not go out immediately,
EVACUATE AND CALL THE FIRE DEPARTMENT.
EVOLUTION
TM
3
READ AND SAVE THESE INSTRUCTIONS
FOR DOMESTIC COOKING ONLY
WARNING
2. NEVER PICK UP A FLAMING PAN — You may be burned or
spread the fire.
3. DO NOT USE WATER, including wet dishcloths or towels - a
violent steam explosion will result.
4. Use an extinguisher ONLY if:
A. You know you have a Class ABC extinguisher, and you
already know how to operate it.
B. The fire is small and contained in the area where it started.
C. The fire department is being called.
D. You can fight the fire with your back to an exit.
* Based on “Kitchen Firesafety Tips” published by NFPA.
1. For indoor use only.
2. For general ventilating use only. Do not use to exhaust haz-
ardous or explosive materials and vapors.
3. To avoid motor bearing damage and noisy and/or unbal-
anced impeller, keep drywall spray, construction dust, etc.,
off power unit.
4. Do not use over cooking equipment greater than 60,000
BTU/hr. as the blower motor will shut down intermittently.
5. Your hood motor has a thermal overload which will automati-
cally shut off the motor if it becomes overheated. The motor
will restart when it cools down. If the motor continues to shut
off and restart, have the hood serviced.
6. The top of the hood MUST NOT BE LESS than 24” and at a
maximum of 30” above cooktop for best capture of cooking
impurities.
7. This hood is not intended to be used as a shelf.
8. Please read specification label on product for further infor-
mation and requirements.
NOTE If hood is to be installed non-ducted:
Purchase a set of (2) non-ducted filters for 30” wide
hoods (Model BPPF30) & 36” wide hoods (Model
BPPF36) or a set of (3) non-ducted filters for 42” wide
hoods (Model BPPF42) from your local distributor or
retailer and attach them to the aluminum mesh filters.
Installer: Leave this manual
with the homeowner.
Homeowner: Cleaning, Maintenance and
Operating instructions on pages 2-4.
Register your product online
at: www.broan.com

Summary

Safety Warnings and Precautions

General Safety Instructions

General safety guidelines for installation and operation to prevent fire, shock, or injury.

Range Top Grease Fire Prevention

Instructions to prevent range top grease fires by managing cooking and cleaning practices.

Grease Fire Injury Prevention

Steps to take to prevent injury during a range top grease fire incident.

Specific Warnings and Cautions

Additional warnings regarding flammable materials, extinguishers, and operational cautions.

Operation and Controls

Fan and Light Controls

Details on how to operate the fan speeds and light settings using push-button controls.

10-Minute Delay Off Feature

Explanation of the automatic 10-minute fan shut-off feature and its activation.

Timer Function

How to set and use the countdown timer feature with audible alerts.

Feature Menu Navigation

Guidance on accessing and adjusting various hood settings through the feature menu.

Advanced Features and Systems

Clock and Display Settings

Instructions for setting the clock and controlling the LED display output.

Sleep Mode and Ambient Light Sensor

Configuration of sleep mode and automatic ambient light sensor for task lighting.

Heat Sentry System

Explanation of the automatic temperature monitoring and fan speed adjustment system.

Fuse Information

Details on the location, type, and replacement of fuses for the control board.

Component Features and Accessories

Make-Up Air Damper & Remote Control

Information on hood compatibility with optional Make-Up Air Damper and Remote Control accessories.

Cleaning and Maintenance

Motor, Filters, and Stainless Steel Care

Instructions for cleaning motor, grease filters, non-ducted filters, and stainless steel surfaces.

Light Bulb Replacement

Halogen Bulb Installation

Step-by-step instructions for replacing halogen light bulbs using the provided tool.

Installation Preparation

Hood Location Planning

Diagrams and instructions for locating and cutting openings for ductwork and electrical connections.

Ductwork Installation

Steps for planning and installing ductwork for ducted hood installations.

Installation Steps

Measuring and Preparing Hood

Guidelines for installation measurements and initial steps to prepare the hood for mounting.

Hood Preparation Procedures

Steps for removing parts, filters, bottom pan, and damper/duct connector from the hood.

Installation Configurations

Non-Ducted Installation Steps

Detailed instructions for setting up the hood for non-ducted (recirculating) installation.

Ducted Installation Steps

Instructions for preparing the hood for ducted installation by installing knockout plates and connectors.

Final Installation and Wiring

Mounting and Duct Connection

Procedures for physically mounting the hood and connecting the ductwork.

Electrical Wiring and Final Assembly

Instructions for connecting the power cable, replacing covers, and installing filters.

Service Parts

Replacement Parts List

A diagram and list of available replacement parts with their corresponding part numbers.

Warranty Information

One Year Limited Warranty

Details of the one-year limited warranty, including coverage, exclusions, and claims process.

Broan EVOLUTION 3 Specifications

General

Brand	Broan
Model	EVOLUTION 3
Category	Ventilation Hood
Language	English