Fabric OS Command Reference 305
53-1001764-01
fcrEdgeShow
2
fcrEdgeShow
Displays the FIDs of all configured EX_Ports.
SYNOPSIS fcredgeshow
fcredgeshow [-fid FabricID]
fcredgeshow --help
DESCRIPTION Use this command without operand to display information about all Fabric IDs (FIDs) that have been
created on the chassis and are assigned to EX_Ports.
When a FID is specified, fcredgeshow displays information for all EX_Ports configured with the
specified FID.
For each FID, the command output includes the following:
FID
Fabric ID of the EX_Port.
EX-port
EX_Port number of the switch.
E_Port
Port number for the remote E_Port.
PWWN
Neighbor switch port WWN.
SWWN
Neighbor switch WWN.
The command output depends on the EX_Port configuration:
• If the EX_Port is online, the command displays the FID, the EX_Port to which it is assigned, the
E_Port, the port WWN and the switch WWN.
• If the EX_Port is offline, the command displays the FID, the EX_Port to which it is assigned, and an
"OFFLINE" message.
• IF no EX_Ports are configured in the switch, the command displays "No EX-port Configured".
• If no EX_Ports are configured within the specified FID, the command displays the following
message: "No EX-ports with FID FabricID."
OPERANDS This command has the following operands:
-fid FabricID
Specifies the FID for which to display the configured EX_Ports.
--help
Displays the command usage.
EXAMPLES To display the EX_Ports configured in the switch:
switch:admin> fcredgeshow
FID EX-port E-port Neighbor Switch (PWWN, SWWN )
-----------------------------------------------------------------
25 11 244 20:f4:00:05:1e:38:a4:cb 10:00:00:05:1e:38:a4:cb
35 10 299 2e:2b:00:05:1e:40:44:02 10:00:00:05:1e:40:44:02
To Next Page
Loading...
