Broil King REGAL Series

Questions and Answers

R
Robert WrightAug 20, 2025
Why does my Broil King Grill have a flickering burner flame or low temperatures on HIGH setting?
- A
  Anthony RogersAug 20, 2025
  A flickering burner flame or low temperatures on the HIGH setting often indicates that the excess flow safety device has been activated in the connection between the cylinder and the barbecue. To resolve this, turn off the LP cylinder valve and set all burners to the OFF position. Disconnect the regulator from the cylinder, wait two minutes, and then re-attach the regulator to the cylinder. Open the cylinder valve slowly and wait one minute before lighting the grill.
M
martinjessicaAug 23, 2025
What to do if I smell gas with my Broil King Grill?
- A
  April NguyenAug 23, 2025
  Immediately shut off the LP cylinder valve. Do not use the appliance until the leak is sealed.
R
Robert JimenezAug 26, 2025
How to fix yellow flame on my Broil King REGAL?
- E
  ealexanderAug 26, 2025
  Some yellow flame is normal. However, if it is excessive, the venturi may be blocked, or the burner ports may be blocked. Remove the burner and clean the venturi. Also, remove the burner and clean it with a soft bristle brush (e.g., a toothbrush).
I
ibowmanAug 28, 2025
Why are there “flare-ups” or grease fires in my Broil King REGAL?
- R
  ramirezjonAug 28, 2025
  Flare-ups or grease fires occur due to excessive grease buildup on the vaporizer or inside the grill's cook box, or because of excessive heat. To resolve this, thoroughly scrape off the Flav-R-Wave and the inside of the cookbox, then vacuum out any debris. Additionally, lower the burner control settings to reduce the heat.
R
riverachristianAug 30, 2025
How to fix decreasing heat and popping sound in Broil King REGAL?
- S
  scottmillerAug 31, 2025
  Decreasing heat and a popping sound may be due to an empty LP gas cylinder or a blocked venturi. Refill the LP gas cylinder. If that doesn't solve the issue, remove the burner and clean the venturi.
J
Jason MooreSep 2, 2025
What to do if the control panel or oven lights on my Broil King REGAL are not working?
- G
  Glenn TaylorSep 2, 2025
  If the control panel or oven lights are not working, first, ensure the unit is connected to a working power outlet with a GFI power cord. Second, check that the transformer output is 12Vac and replace it if needed. Third, clean the connections and ensure all connectors are pushed together firmly. Fourth, replace the bulbs.
P
Patrick RogersSep 4, 2025
How to fix regulator humming noise in my Broil King Grill?
- S
  Sabrina GainesSep 4, 2025
  A humming noise from the regulator usually means the cylinder valve was opened too quickly. Open the cylinder valve slowly to resolve this.
C
Christopher WebbSep 7, 2025
How to fix flames beneath the control panel (flashback fire) in my Broil King REGAL Grill?
- J
  Jeremiah CobbSep 7, 2025
  If you see flames beneath the control panel, which indicates a flashback fire, it's likely that the venturi is blocked. Remove the burner and clean the venturi to resolve this issue.
S
ssaundersSep 9, 2025
What to do if I detect a leak at the cylinder, regulator, or other connection on my Broil King REGAL Grill?
- L
  luis90Sep 10, 2025
  If you detect a leak at the cylinder, regulator, or any other connection, it could be due to a loose regulator fitting or a gas leak in the hose, regulator, or control valves. First, try tightening the fitting and then perform a “Leak Test.” If the problem persists, contact an authorized service center.
M
mccallmelanieSep 12, 2025
How to fix ignitor not working on Broil King REGAL Grill?
- G
  gregory21Sep 12, 2025
  If the ignitor is not working, it could be due to a dead ignitor battery, disconnected ignitor wires, a misaligned electrode on the burner, or an ignitor malfunction. Replace the battery. Ensure the main burner and side burner electrode wires are all connected. Realign the electrode and clear any surrounding debris from the area. If none of these steps work, use the match lighting procedure.