To Next PageTo Next Page
Need help?Do you have a question about the Broncolor Grafit 2/4 and is the answer not in the manual?
Identifies the main power switch for the unit.
Allows selection of input voltage (110V/230V).
Protects against electrical faults.
Port for triggering flashes via cable.
Socket for connecting the main power cable.
Connection points for lamp bases (I, II, III).
Individual on/off controls for lamp bases (1, 2, 3).
Adjusts flash energy level using +/- keys.
Controls for optical and infrared triggering.
Shows current flash energy setting.
Button to switch the modelling light on/off.
Key for test flash and visual indicator of charge readiness.
4-line display and cursor keys for menu navigation.
Keys for resetting functions and accessing auxiliary settings.
Setting the unit to the required mains voltage.
Ensuring connection via an earthed mains plug.
Using the mains switch to start the unit.
Using +/- keys for 4 f-stop range adjustment.
Programming fractional power levels (1/10 or 1/3 f-stop).
Outlets marked I to III, individually switchable.
Switching on modelling lamps via 'mod' key.
Adapting brightness to power pack output levels.
Reducing intensity to avoid mains overload.
Selective control and switching off before moving.
Activating slave cell and IR receiver.
Using two channels for infrared transmitters.
Using sync cables for flash release.
Manual release of power pack when energy is available.
Operating via Servor 3 and Servor e remote controls.
Assigning addresses for individual power pack control.
Using separate channels for remote control.
Green LED and optional buzzer indicate full charge.
Warning signal for flash discharge failure.
Accessing settings via toggle and +/- keys.
Displaying lamp power in joules or percentage.
Selecting proportional levels (prop1-prop5, full, low).
Automatic triggering of a selected number of flashes.
Defining time between flashes for sequence delay.
Delaying the triggering of the first flash.
Option for determining release sequence of two power packs.
Extending charging time for weak power supply.
Storing and recalling settings.
Dimming modelling light during recycling time.
Switching the audible signal for charge completion on/off.
Selecting channels for selective triggering.
Setting workstation or power pack address.
Counting released flashes and total discharges.
Choosing display increments (1/10 or 1/3 f-stops).
Clearing programming functions on loss of mains power.
Displays the software release of the EPROM.
Country code for sale and service.
Fault messages framed with '!' characters.
Fan speed increases after some flashes.
Unit powers down temporarily due to overheating.
Message displayed in case of old flash tube afterglow.
Automatic disconnection and restart capability.
Newly connected lamp bases are activated automatically.
Procedure for replacing flash tubes in lamp bases.
Replacing the modelling light halogen lamp.
Voltage compatibility and modelling lamp socket differences.
Fan cools flash tube and modelling lamp.
Automatic shutdown of modelling light on overheating.
Mechanical interlocks for preventing disconnection.
Bayonet fitting for attaching reflectors.
Using only indicated fuse types.
Technical specifications for flash energy and f-stop.
Technical data on flash duration and charging.
Specifications for ready display and power output distribution.
Details on controls, control range, and modelling light.
Overview of additional functions and flash release types.
Data on sync sockets and power requirements.
Physical specifications of the unit.
General| Brand | Broncolor |
|---|---|
| Model | Grafit 2/4 |
| Category | Power Pack |
| Language | English |
