1
Table of Contents
Section 1 - General Information
1.1 Unpacking
1.2 Contents
1.3 General Description
1.4 Circulator Pump
1.5 Pump Inlet and Outlet Connections
1.6 Closed Loop Circulation
1.7 Reservoir Purge
1.8 Ambient and Cooling Coil
Section 2 - Standard Controller Information
2.1 Front and Rear Panels
2.2 Heater/Pump Assembly
Section 3 - Operation
3.1 Circulator Location
3.2 Filling the Reservoir
3.3 Power
3.4 Setting the Safety Set Point
3.5 Selecting Temperature Units
3.6 Setting the High Limit
3.7 Setting the Set Point Temperature
3.8 User-Defined Preset Temperatures
3.9 Local Lockout Feature
3.10 Stick-on Strips for Preset Buttons
3.11 Auto-Refrigeration Operation
3.12 Controller Display Messages
Section 4 - Calibration and Maintenance
4.1 Calibration
4.2 Heater
4.3 Pump Motor
4.4 Cleaning
4.5 Maintaining Clear Bath Water
4.6 Condenser, Air Vents, and Reusable Filter
(Refrigerating/Heating Circulators Only)
Section 5 - Troubleshooting
5.1 Unit Will Not Operate (no heat, cooling, or pumping)
5.2 No Pumping
5.3 Slow or Insufficient Pumping
5.4 No Heating
5.5 Insufficient Heating
5.6 No Cooling or Insufficient Cooling
5.7 Triac Failure
Section 6 - Reservoir Fluids
Section 7 - Service and Technical Support
7.1 Replacement Parts
Section 8 - After-sale Support
Section 9 – Warranty
Section 10 – EC Declaration of Conformity
To Next Page
Loading...
