6
SYNCING THE Bluetooth TO YOUR iPad Tablet
1. Power on your iPad Tablet.
2. Slide the On/Off switch on the Bluetooth Keyboard Case to “on”.
Both the Bluetooth LED and the power LED illuminators will light up
for a few seconds and then shut off.
3. Press the Connect button on the Bluetooth Keyboard Case. The Power LED
will illuminate and the Bluetooth LED will flash.
4. Select the “Settings” icon on your iPad Tablet’s screen.
5. Locate and select “Bluetooth” in your iPad Tablet’s “General” menu.
6. Under “Devices” on your iPad Tablet, select the Bluetooth Wireless Keyboard.
7. The iPad Tablet will now prompt you to enter your tablet Bluetooth password and
press either the Return or Enter key using the Bluetooth Keyboard Case.
8. The iPad Tablet screen should now show the Bluetooth Wireless Keyboard has
connected successfully.
9. The Power LED will remain illuminated while the keyboard is powered on.
10. Slide the On/Off switch to “off” when you are done using the keyboard.
11. If your iPad Tablet goes into standby mode, the Bluetooth Keyboard Case
should still be synced. If you power-off your iPad Tablet you may need to
re-sync. If you use the Bluetooth Keyboard Case with a new iPad Tablet,
or it doesn’t connect properly, follow the steps above to re-sync.
Note: The Bluetooth Keyboard Case will automatically go into standby
mode after 15 minutes of non-use in order to preserve battery life.
Just press any key to reactivate the keyboard.
797195_INS0911_Bluetooth Keyboard Colors
Wx4.75”H_Output:100%_Prints:1/1,Blk
To Next Page
Loading...
