6
Assemble and Installation
1. Charge the device via the USB cable inside the package as
follow. Battery is included. Charge the repellent for six hours,
unplug the device and plug again and charge it for another
6 hours. Repeat it for the third time.
2. Consider a suitable place for the repellent regarding the points
mentioned in Important Tips section. The repellent can be
installed in a flowerbed, on the fence, against the wall, etc. for
bigger animals it is better to put the repellent above ground
level. The repellent should be set towards the area which should
get protected. As a reminder, the solar panel of the repellent
should be exposed to enough sunlight and the solar panel on
the top of the device should not be covered.
3. If the repellent is going to be mounted in the ground, insert
the rod carefully into the ground. It is suggested first dig a
hole and put the device in the ground to prevent any kind of
damage. Note that 12 cm of the rod should be out of the ground.
* Please send Email to contact@reymonbroox.com for further
guidance and advice.
To Next Page
Loading...