Need help?Do you have a question about the Brother CE-8080 and is the answer not in the manual?
General| Fonts | 5 |
|---|---|
| LCD Display | Yes |
| Bobbin Winding System | Automatic |
| Speed Control | Yes |
| Maximum Stitch Width | 7mm |
| Maximum Stitch Length | 5mm |
| Drop-in Bobbin | Yes |
| Free Arm | Yes |
| Type | Sewing and Embroidery |
| Needle Threader | Automatic |
| Stitch Length | 0-5mm |
| Stitch Width | 0-7mm |
Diagram showing major mechanical components of the sewing machine.
Explanation of how power is transmitted through various mechanisms.
Diagrams showing the location of electronic parts within the machine.
A diagram illustrating the machine's electronic control system.
Explains the function of various electronic components.
Location diagram and steps for removing main external parts.
Procedures for disassembling electrical components and motors.
Steps for disassembling needle and upper shaft mechanisms.
Steps for disassembling the fabric feeding mechanism.
Steps for disassembling the bobbin winder.
Step-by-step guide for disassembling main external parts.
Procedures for disassembling electrical components and motors.
Steps for disassembling needle and upper shaft mechanisms.
Procedures for disassembling the bobbin winder.
Steps for disassembling the feed and rotary hook mechanisms.
Procedures for disassembling the needle and presser components.
Procedures for entering test modes and operating the machine.
How to adjust the timing belt tension.
How to adjust the motor belt tension.
How to adjust the upper thread tension.
Adjusting needle drop for the left base line.
Adjusting the position of the rotary hook unit.
Adjusting the horizontal needle clearance.
Adjusting the needle bar's upward movement.
Adjusting the overall height of the needle bar.
Adjusting clearance between needle and hook.
Adjusting the needle threading mechanism.
Adjusting presser bar height and alignment.
Adjusting the feed dog's forward/backward movement.
Adjusting the bobbin winding mechanism.
Adjusting the buttonhole lever switch position.
Adjusting front/back position of needle and presser foot.
Adjusting feed dog position.
Adjusting the height of the feed dog.
Adjusting the inner rotary hook bracket.
Adjusting lower thread tension.
List of error codes and their probable causes.
Troubleshooting steps for displayed error messages.
Troubleshooting steps when the machine has no power.
Troubleshooting steps for pulse motor issues.
Troubleshooting steps for pattern selection problems.
Troubleshooting steps for main motor failure.
Troubleshooting steps for unstable motor rotation.
Troubleshooting steps for incorrect sewing patterns.
Troubleshooting steps for buttonhole issues.
Troubleshooting steps for non-functional operation buttons.
Troubleshooting steps for foot controller issues.
Troubleshooting steps for bobbin winding problems.
Troubleshooting steps for LED lamp failure.
Troubleshooting steps for LCD display issues.
Troubleshooting steps for buzzer failure.
Instructions for wiring the needle bar and presser module.
Instructions for wiring the power supply unit.
Instructions for wiring the front cover components.
To Next Page