Brother HL-5140 - Page 160

HL-5130/5140/5150D/5150DN Service Manual
4-59
(5) Remove the cup S M3x6 Taptite screw.
(6) Remove the ground spring.
(7) Remove the six bind B M4x12 Taptite screws.
(8) Remove the cup S M3x6 Taptite screw.
(9) Remove the cup S M3x6 Taptite screw, and then remove the sub gear plate.
(10) Remove the LD harness 5P from the drive unit.
(11) Remove the drive unit.
(12) Disconnect the connector for the main motor harness from the main motor ASSY.
Fig. 4-104
Taptite, bind B M4x12
Taptite, bind B M4x12
Taptite, cup S M3x6
Taptite, cup S M3x6
Main motor harness
Taptite, cup S
M3x6
Sub gear plate
Frame L
Drive unit
Main motor ASSY
Ground spring
LD harness 5P