2-23
Confidential
No Paper MP Reload paper in MP
Tray.
When paper was fed from the
MP tray, the MP paper empty
sensor detected that no paper
was in the MP tray.
9301 2-49
No Paper T1 Reload paper in
Tray 1.
When paper was fed from the
paper tray, the T1 paper feed
sensor detected that no paper
was in the paper tray.
9302 2-49
-
When paper was fed from the
paper tray, the engine status
detected that no paper was in
the paper tray.
--- 4.2.1
No Toner Open the Front
Cover, then install
Toner Cartridge.
The new toner sensor detected
that no toner cartridge was set.
6101 2-41
The new toner box sensor
detected that no toner box was
set.
6106 2-41
Out of Memory Press Go for 2
seconds.
The memory is insufficient to
expand the data of PC-Print.
C700 2-51
Paper Low T1 -
Detected that the paper is
running out when the paper
feed motor drive and T1 paper
empty sensor turned ON.
--- 4.11.3
Print Data Full Print Data is full.
Press Cancel and
delete the
previously stored
data.
The memory used to store
secure print data exceeded the
memory size for secure print
data.
C800 2-51
Print Unable
01
Turn the power off
and then back on
again.
ASIC error or motor driver error
occurred.
0102 2-33
Print Unable
02
Turn the power off
and then back on
again.
Cannot detect the synchronized
signal of the paper feed motor.
The speed of the paper feed
motor does not stabilize within
the specified time.
0201 2-33
Print Unable
03
Turn the power off
and then back on
again.
Cannot detect the lock signal of
the polygon motor for the laser
unit. (second time)
0300 2-33
Print Unable
04
Turn the power off
and then back on
again.
BD sensor failure (second time)
0401 2-34
Error message
Description
Error
codes
Refer
to:
Initial display Scroll
To Next Page
Loading...
