3-32
Confidential
(3) Remove the Taptite pan (washer) B M4x12DA screw to remove the LED ground wire. Pull
out the LED ground wire through the Hole of the Side frame R.
Fig. 3-19
Harness routing:
Refer to “3. High-voltage power supply PCB, Fan harness, LED ground wire”.
(4) Release each Hook to remove the Damper stopper from the Top cover ASSY. (Two
locations)
Fig. 3-20
LED ground wire
Taptite pan (washer) B M4x12DA
Hole of Side frame R
Damper stopper
Damper stopper
Hook
Hook
Hook
Hook
Top cover ASSY
To Next Page
Loading...
