CHAPTER 6 EPSON - 12
Reset printer / change emulation mode
EscCR<mode> (27)(13)mode <1Bh><0Dh>mode
This command enables you to switch emulation mode or to reset the printer.
Change emulation mode by setting mode to the appropriate letter or pair of letters. Set mode to 'D' to switch
to Diablo mode, 'H' to switch to LaserJet mode, 'I' to switch to IBM Proprinter XL mode, 'AB' to switch to
BR-Script Batch mode, 'AI' to switch BR-Script Interactive mode, 'GL' to switch to HP-GL mode.
If you set mode to 'E' in Epson FX-850 mode , a printer reset is performed.
If you set mode to 'FD', to reset the printer to its factory default settings, LaserJet mode (the factory default
emulation mode) is selected and the LaserJet factory default environment is restored. For a list of the factory
default settings see the sub-section "Factory default environment" in Chapter 2 "PCL" of this manual.
On receiving this command the printer prints any remaining data and performs a page eject (unless the
current page is blank). The newly selected emulation mode's default settings come into effect, except when
mode is set to 'FD'.
LPRINT CHR$(27); CHR$(13); CHR$(73); 'Change to IBM Proprinter mode
User reset
EscCR!#R (27)(13)(33)#(82) <1Bh><0Dh><21h>#<52h>
# = 0, the printer restores to the current user setting.
# = 1, the printer restores to user settings 1.
# = 2, the printer restores to user settings 2.
Paper Input Control
EscEMn (27)(25)n <1Bh><19h>n
n Value HL-1660e/2060/3260N/2460/7050/1650/1670N/1850/1870N/5050/5070N/
5150D/5170DN/6050/6050D/6050DN/8050N/5240/5250DN/5270DN/5280DW
/
5340D/5350DN/5370DW/5380DN//5440D/5450DN/5470DW/6180DW
n = 0 Initialize the feeder mode.
n = 1 Feed from the MP tray. (Except for HL-8050N)
n = 2 Feed from Tray 1.
n = 3 Feed from Tray 2.
n = 4 Feed from Tray 3.
n = 5 Feed from Tray 4.(Only HL-3260N/2460/7050/8050N)
n = R Eject paper.
n Value HL-1050
n = 0 Initialize the feeder mode.
n = 1/2 Feed from the tray.
n = R Eject paper.
n Value HL-1250/1270N/1450/1470N/P2500/2400C/2400Ce/3400CN/2600CN/3450CN/
2700CN
n = 0 Initialize the feeder mode.
n = 1 Feed from the Tray 1.
n = 2 Feed from the Tray 2.
n = R Eject paper.
n Value HL-2070N
n = 0 Initialize the feeder mode.
n = 2 Feed from the tray.
n = R Eject paper.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
