Brother MFC-L2712DN - Page 101

(9)
Cli
ck t
he [
OK]
sho
wn
as (
J).
The Execute Setting screen shown on the right appears and
the laser adjusted value is written to the machine.
(10)
Click the [OK] shown
as (L) and
close the Execute Se
tting
screen.
(11)
Click the [C
ancel] shown as
(K) and close the
Input
information screen.
(12)
Click the [Get information] shown as (D).
The machine maintenance information appears.
(13)
In the maintenance information, check that the value in the
“Laser Adjusted
value(Video)” field, and the value in the “Laser Adjusted value(Position)” field are same
as the value entered in procedure (8).
(14)
Click the [C
ancel] shown as (M)
and
close the Get information screen.
(15)
Tur
n OFF the power switch of the
machine and disconnect the USB
cable from the machine and
computer.
(L)
(M)