Brother MFC-L2712DN - Page 105

1.3.13
Adjust printable range for each spee
d level (Function code 46)
<Function>
This function is to adjust the printing position in horizontal / vertical direction.
Position can be adjusted
in 11 steps from -0.5% to 0.5% (Printing width gets smaller when
the value is negative).
<Operating Procedure>
(1)
Press the [
4], and the
n the [6] in th
e initia
l state o
f mainte
nance mod
e. For model
s
without keypad, press the [
▲
] or [
▼
] to display “MAINTENANCE 46” on the LCD and
press the [OK]. “MAIN SIZE SET” is displayed on the LCD.
(2
)
Pr
es
s
th
e
[
▲
] or [
▼
] to display “PRINT TEST PTN” on the LCD, and press the [SET] or
[OK]. “PRINTING” is displayed on the LCD, and the print adjustment test pattern (refer to
the
next page
) is printed on a sheet of paper.
(3)
Adjust t
he line so t
hat the wid
th is 10 mm in h
orizon
tal / vert
ical di
rection
. Press the [
▲
]
or [
▼
] to display desired direction on the LCD.
•
Ho
ri
zo
nt
al
di
re
ct
io
n
→
“MAIN SIZE SET”
•
V
ert
ic
al
di
re
ct
io
n
→
“SUB SIZE SET”
Press the [SET] or
[OK]. “SET: 0.0 %” is displayed on the LCD.
(4)
T
o make
the pri
nt wi
dth sm
aller
, pres
s the [
▼
] to decrease the value. Press the [SET] or
[OK] after adjusting the value.
(5)
After ad
justme
nt, repeat th
e procedu
re (2) to chec
k if the adjus
tment was co
rrectly do
ne.
(6)
Press the [
X] or [S
top] to retu
rn the mac
hine to the i
nitial s
tate of ma
intena
nce mode
after adjusting the value.