Brother MFC-L2712DN - Page 109

1.3.15
Fine-tune scanning
position (Function cod
e 54)
<Function>
This function is used to adjust the scanning start/end positions.
<Operating Procedure>
(
1
)
•
For models with ADF and keypad
Press the [5], and then the [4] in the initial state of maintenance mode. “SCAN START
ADJ” is displaye
d for two seco
nds, and th
en “0: ADF
1: FB” is disp
layed on th
e LCD.
To adjust the ADF scanning position, press the [0] and proceed to the procedure (2). To
adjust the FB scanning position, press the [1] and proceed to the procedure (3).
•
For models with ADF but no keypad
Press the [
▲
] or [
▼
] to display “MAINTENANCE 54” on the
LCD and press the [OK].
“SCAN START ADJ” is displayed on the LCD for two seconds and “
▲
: ADF
▼
: FB”
appears. To adjust the ADF scanning position, press the [
▲
] and proceed to
the procedure
(2). To adjust the FB scanning position, press the [
▼
] and proceed to the procedure (3).
•
For mod
els w
ithout
ADF
, proc
eed to
the pro
cedure
(2).
(2)
“0:MAIN
1:TP 2:HP
” is displ
ayed on the
LCD. Pres
s the [0] to a
djust th
e main sc
anning.
Press the [1] to adjust the vertical scanning. Press the [2] to adjust the rear end side of
the vertical scanning.
•
Fo
r dup
le
x sc
an
ni
ng mo
de
ls
“0:FRONT 1:BACK” is displayed on the LCD. Press the [0] to adjust the first side.
Press the [1] to adjust the second side. Proceed to the procedure (4).
•
For
sin
gle
-sid
e sc
ann
ing
mode
ls
Proceed to the procedure (4).
(3)
“0:MAIN 1
:SUB” is di
splaye
d on the LCD
. Press the [
0] to adju
st the mai
n scanni
ng.
Press the [1] to adjust the vertical scanning, and proceed to the procedure (4).
(4)
The curre
ntly set value is di
splaye
d on the LCD. T
o increas
e the adjustm
ent value, pre
ss
the [
▲
]. T
o decrease the adjustment value,
press the [
▼
]. (Refer to the figure below)
(5)
Press th
e [SET] aft
er adjus
ting the va
lue. “Acc
epted” is d
ispla
yed on the LC
D, and the
machine returns to the initial state of maintenance mode.
Note:
When the [X] is pressed, t
he machine stops correcting the adjusting value and
returns to
the initial state of maintenance mode.