Brother MFC-L2712DN - Page 14


Standard Telephone and FCC Notices (MFC models only)
These notices are in effect on models sold and used in the United States only.
When programming emergency numbers or making test calls to emergency numbers:
•
Remain on the line and brie
fly explai
n to the dispatche
r the reason for the call before
hanging up.
•
Perform thes
e activiti
es in the off-pea
k hours, such as early morn
ing or late evening.
This equipment complies with Part 68 of the FCC rules and the requirements adopted by the
ACTA.
On the backside of
this equipment is a
label that contains, among
other information, a
product identifier in the format US: AAAEQ##TXXXX. If requested, this number must be
provided to the telephone company.
Y
ou may safely connect t
his equipment to the telep
hone line by means of
a standard modular
jack, USOC RJ1
1C.
A plug and jack used to connect this equipment to the premises wiring and telephone
network must comply with the applicable FCC Part 68 rules and require
ments adopted by the
ACTA. A compliant telephone cord and modular plug is provided with this product. It is
designed to be connected to a compatible modular jack that is also compliant. (See
installation instructions for details.)
The Ringer Equivalence Number (REN) is use
d to determine the number of d
evices that may
be connected to a telephone line. Excessive RENs on a telephone line may result in the
devices not ringing in response to an incoming call. In most but not all areas, the sum of
RENs should not exceed five (5
.0). T
o be certain of the
number of devices that may
be
connected to a line,
as determined by the total RE
Ns, contact the local telephone company.
For products approved after July 23, 2001, the REN for this product is part of the product
identifier that has the format US:AAAEQ##TXXXX
. The digits represented by ## are the REN
without a decimal point (e.g., 06
is a REN of 0.6). For ea
rlier products, the REN is separately
shown on the label.
If this equipment causes harm to the telephone network, the telephone company will notify
you in advance that temporary discontinuance of service may be required. But if advance
notice is not practical, the telephone company will notify the customer as soon as possible.
Also, you will be advised of your right to file a complaint with the FCC if you believe it is
necessary. The telephone company may make changes in its facilities, equipment,
operations or procedures that could affect the operation of the equipment. If this happens the
telephone company will provide advance notice in order for you to make necessary
modifications to maintain uninterrupted service.
If trouble is experienced with this equipment, for repair or warranty information, please
contact Brother Customer Service (see the Online User's Guide: Brother numbers). If the
equipment is causing harm to the telephone network, the telephone company may request
that you disconnect the equipment until the problem is resolved.
Connection to party line service is subject
to state tariffs. Contact the state public utility
commission, public service commission or corporation commission for information.
If your home has specially wired alarm equipment connected to the telephone line, ensure
the installation of this equipment does not disable your alarm equipment. If you have
questions about what will disable alarm equipment, call your telephone company or a
qualified installer.
If you are not able to solve a problem with your product, contact Brother Customer Service
(see the Online User's Guide: Brother numbers).