Brother MFC-L2712DN - Page 74

(3)
Open the AD
F unit. Re
lease th
e Hook of the F
FC holder ASS
Y
, and remov
e the FFC
holder ASSY from the Document scanner unit.
(4)
Lift th
e ADF unit, a
nd remove t
he ADF unit f
rom the Doc
ument sca
nner unit w
hile push
ing
the Hook of the Hinge R. Pull out the ADF sensor harness unit from the Hole.
(5)
Remov
e the FFC hol
der ASSY from t
he ADF sen
sor harn
ess unit an
d the Seco
nd side CI
S
flat cable.
Fig. 3-30
Harness routing: Refer to
“
2
.
ADF unit
”
.
Fig. 3-31
Assembling Note:
•
If you
replac
ed the
ADF un
it, re
fer to
“5.
IF YOU REPLACE THE ADF
UNIT
, FIRST
SIDE CIS UNIT, SECOND SIDE CIS UNIT OR DOCUMENT SCANNER UNIT” in
Chapter 4
to configure settings.
•
Attac
h the FFC holder ASS
Y to the ADF sensor ha
rness uni
t and the Secon
d side CIS
flat cable as shown in the figure below.
Hinge R
FFC holder ASSY
Hook
ADF unit
Hook
Document scanner unit
Hole
ADF sensor
harness unit
Second side CIS
flat cable
FFC holder ASSY
ADF sensor harn
ess unit
Double-sided tape
Second side CIS flat cable