3 - 2
PRE-START INSTRUCTIONS section 3
Decrating and Set-up
• Remove the Sod Cutter from the crate.
To prevent possible personal injury, do not lift
the unit single handed. Use an adequate lifting
device. (i.e. hoist or fork lift)
BEFORE STARTING:
• READ SAFETY DECALS.
• Check engine and gearbox oil levels.
• Prior to starting and operating, place the
machine on it's kickstand (1). (Refer to
Drawing 1)
(1). Fold handle (2) back into suitable operating
position (Refer to Drawing 1).
(2). Visually check all moving parts and
fasteners. If any parts or fasteners are broken or
loose, replace or tighten.
(3). Before attempting to start engine read
Section 4 of this manual and follow the
instructions in the engine manufacturers
owner's manual.
(4). Fill the fuel tank with recommended fuel.
Draw ing 1
To Next Page
Loading...
