the rotary bolt. If it does, work the
breechblock rearward very slightly by
pulling rearward on the operating handle
(several times if necessary), until the barrel
slips into position.
Install the magazine cap. Make absolutely
sure that the magazine cap is tightened
fully, and that there is no play present in
the forearm. Your A-500 is now assembled.
PART BY PART ASSEMBLY — If the forearm,
recoil spring and buffer have already been dis-
assembled (as after cleaning) proceed to step 2.
Disassemble the forearm assembly from
the magazine tube Take the receiver in
To Next Page
Loading...